Turn it down too low and you will have a dark waterfall. Mine is set to 50%. Turn it up too high and the waterfall in DM780 will have too much noise. Under MENU>SET>Connectors there is an important transmitter setting, but let me mention a receiver setting first.ĪCC/USB AF Output Level controls the amount of audio the Icom 7300 sends to your software.
Icom 7300 Internal Menu Transmitter Settings Tap RF POWER with your finger, using the MULTI knob again, turn it and and set RF POWER to 100%. To set: Push in the MULTI knob on the radio. I was too scared of it, but I haven’t had any problems using the Icom 7300 and I’ve used Windows 7,10, MacOS, and Linux. Good read! Icom 7300 RF POWERīack in the days of Windows 95 and my old Kenwood transceiver I didn’t set my output power on the radio to 100% or 100 watts. Some more information on this exists at . There is no ambiguity in what he says. It states, “When operating in the SSB data mode, adjust the device’s output level within the ALC zone.” For more information on this see -31 of the full manual.
I’ve found that I don’t have any ALC deflection most of the time and when I do, it isn’t a bad thing with this transceiver. With the Icom 7300 it is less of an issue. In digital operation there has always been the issue of ALC causing poor signal quality. To set: Tap the USB button on the LCD with your finger and when the “MODE” menu comes up, tap the DATA button. Experiment some and you’ll see how it works. It can be a little tricky at first getting in and out of this mode. On the Icom 7300 we use USB-D for digital operation. If you have a suggestion(s), please feel free to comment below.
0 kommentar(er)
